Bellian high-efficiency Sand Making Machine is a new generation of HVI shaping and sand making machine, which is comprehensively developed and developed based on the introduction of foreign technology and further absorbing the advantages of vertical impact crushers. , the equipment can be widely used in construction, mining, metallurgy, highway and other industries, so how to prevent the failure of the sand making machine in the sand making production line?
First, the sand making machine has abnormal vibration during the production process
1. The material entering the sand making machine is too large, you can check the particle size of the feed;
2. The impeller of the sand making machine is unevenly worn, check the wear of the impeller and the hammer head, and stop the machine in time for repair if there is wear;
3. The impeller of the sand making machine is unbalanced and replaced in time if necessary;
4. The foundation of the sand making machine is not handled properly, check the anchor bolts and tighten them.
Second, the sand making machine bearing heat
1. The bearing of the sand making machine is short of oil, check and refuel in time, too much refueling will cause the bearing to heat up, so be sure to check the oil level when refueling;
2. The bearing of the sand making machine is damaged, check and replace the bearing in time;
3. The upper cover of the bearing body of the sand making machine is too tight, and the bolts should be adjusted to a moderate degree of tightness.
3. The discharge size of the sand making machine is too large
1. Check the wear of the hammer head of the sand making machine, and repair and replace the worn hammer head in time;
2. Check the wear of the impact plate on the side of the sand making machine and replace it if necessary;
3. Check the feed particle size of the sand making machine. If the feed particle size is too large, it will also affect the output particle size.
Four, sand making machine belt flip
1. It shows that the sand making machine belt is worn out and the V-belt needs to be replaced;
2. For the problem of belt conveyor assembly, it is necessary to adjust the pulleys on the same plane;
3. Check the quality of the V-belt itself.
The above are for the failures that often occur in the sand making machine in the sand making production line, but for the sand making machine manufacturer, it will largely guarantee the quality of the product, and continue to innovate in equipment technology to ensure that the interests of customers are maximized. .
